SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2008CHEVY EXPRESS G2500, VAN CARGO, 6.6 6REPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 1727 (EXTERIOR TRIM SYSTEM)REPAIR INSTRUCTIONSREAR SPOILER REPLACEMENT (STS-V)
2008 Chevrolet Chevy Express G2500, Van Cargo, 6.6 6

Rear Spoiler Replacement (STS-V)

2008 Chevrolet Chevy Express G2500, Van Cargo, 6.6 6SECTION Rear Spoiler Replacement (STS-V)
WARNING: This page is about a different car, the 2009 Cadillac STS. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: View of Rear Spoiler Inner Panel and Bolts
GM2094370Courtesy of GENERAL MOTORS CORP.
Callout Component Name

Preliminary Procedures

  1. Remove the rear compartment lid inner panel trim. Refer to Rear Compartment Lid Inner Panel Trim Replacement .
  2. Remove the rear compartment inner panel access plugs to gain access to the outboard spoiler bolts.
1 Rear End Spoiler Bolts (Qty: 4)
CAUTION: Refer to Fastener Caution .

Tighten:  9 N.m (80 lb in)
2 Rear End Spoiler Assembly

Procedure

  1. Disconnect the high mounted stop lamp electrical connector.
  2. Carefully lift and pull the spoiler rearward in order to remove from the rear compartment lid.
  3. Transfer the high mounted stop lamp as needed.
  4. Ensure the foam gaskets are in place on the high mounted stop lamp alignment pins prior to re-assembly to the new spoiler.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.