Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2008CHEVY EXPRESS G2500, VAN CARGO, 6.6 6REPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 1672 (HYBRID CONTROLS - DTC P181C TO DTC P2797)DTC P2797CIRCUIT/SYSTEM VERIFICATION
2008 Chevrolet Chevy Express G2500, Van Cargo, 6.6 6
Circuit/System Verification
2008 Chevrolet Chevy Express G2500, Van Cargo, 6.6 6SECTION Circuit/System Verification
WARNING: This page is about a different car, the 2009 GMC Sierra and 2009 Chevrolet Silverado. However, it is still accessible from the selected car via links, so may be relevant.
- Ignition ON with the engine OFF, command the Aux. Trans. Pump Speed to 50 percent with the scan tool. Attempt to maintain pump operation for at lease 60 seconds.
- Observe the aux. trans. fluid pump actual display and the aux. trans. fluid pump commanded displays with the scan tool. Actual pump speed should be maintained within 10 percent of commanded. The pump should not make excessive noise ro stall.
- If the actual speed is within 10 percent of commanded speed an electrical fault condition is not currently present, if an aux. trans. fluid pump pressure fault is suspected, test the aux. trans. pump line pressure output. Refer to Line Pressure Check .
- If the difference between actual and commanded speed is greater than 10 percent, the pump is noisy, or the pump stalls, proceed to Circuit/System Testing.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.