Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2008CHEVY EXPRESS G2500, VAN CARGO, 6.6 6REPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 1635 (KEYLESS ENTRY SYSTEM AND REMOTE FUNCTIONS)DESCRIPTION AND OPERATIONKEYLESS ENTRY SYSTEM DESCRIPTION AND OPERATION (WITH ACCESSORY 2 WAY REMOTE)UNLOCK DRIVER DOOR ONLY
2008 Chevrolet Chevy Express G2500, Van Cargo, 6.6 6
Unlock Driver Door Only
2008 Chevrolet Chevy Express G2500, Van Cargo, 6.6 6SECTION Unlock Driver Door Only
WARNING: This page is about a different car, the 2009 GMC Sierra, 2009 GMC Cab & Chassis Sierra, 2009 Chevrolet Silverado, and 2009 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
Momentarily press the transmitter UNLOCK button in order to perform the following functions:
- Unlock only the driver door.
- Illuminate the interior lamps for a determined length of time, or until the ignition is turned ON.
- Flash the exterior lights, if enabled through personalization.
- Disarm the content theft deterrent (CTD) system, if equipped.
- Deactivate the CTD system when in the alarm mode.
- Indicate the driver door is unlocked on the transmitter LCD-The LCD driver door segment will disappear.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.