SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2008CHEVY EXPRESS G2500, VAN CARGO, 6.6 6REPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 1534 (HYBRID ENGINE CONTROL SYSTEM)DIAGNOSTIC INFORMATION AND PROCEDURESDTC P0AB9CIRCUIT/SYSTEM DESCRIPTION
2008 Chevrolet Chevy Express G2500, Van Cargo, 6.6 6

Circuit/System Description

2008 Chevrolet Chevy Express G2500, Van Cargo, 6.6 6SECTION Circuit/System Description
WARNING: This page is about a different car, the 2008 GMC Yukon and 2008 Chevrolet Tahoe. However, it is still accessible from the selected car via links, so may be relevant.

This vehicle does not use a 12V starter motor to crank the internal combustion engine. A much more powerful 300V drive motor generator located within the transmission is utilized to crank the engine. The 300V drive motor generator can rotate the engine to operating speed (800 RPM) within just a few hundred milliseconds. The HPCM can detect a condition where the engine is cranking but does not start or has stalled.

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.