SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2008CHEVY EXPRESS G2500, VAN CARGO, 6.6 6REPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 1530 (POWER STEERING SYSTEM)REPAIR INSTRUCTIONSPOWER STEERING FLUID COOLER REPLACEMENT (WITH HYDROBOOST)INSTALLATION PROCEDURE
2008 Chevrolet Chevy Express G2500, Van Cargo, 6.6 6

Installation Procedure

2008 Chevrolet Chevy Express G2500, Van Cargo, 6.6 6SECTION Installation Procedure
WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2008 GMC Yukon XL, 2008 GMC Yukon, 2008 Chevrolet Tahoe, 2008 Chevrolet Suburban, and 2008 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Power Steering Cooler & Bolts (With Hydroboost)
    GM686121Courtesy of GENERAL MOTORS CORP.
  1. Install the power steering fluid cooler (1) to the vehicle.
    2. NOTE: Refer to Fastener Notice .
  2. Install the power steering fluid cooler bolts (2).

    Tighten:  Tighten the bolts to 9 N.m (80 lb in).

    3. Fig 2: View Of Power Steering Cooler Hoses, Power Steering Gear & Pump (With Hydroboost)
    GM686126Courtesy of GENERAL MOTORS CORP.
  3. Connect the power steering fluid cooler hose (4) to the power steering pump (1).
  4. Connect the power steering fluid cooler hose (3) to the steering gear (2).
  5. Clean any excess fluid from the vehicle and remove the drain pans.
  6. Install the radiator grille reinforcement support, if equipped. Refer to Radiator Grille Reinforcement Support Replacement .
  7. Install the fascia grille. Refer to Fascia Grille Replacement (Z71) or Fascia Grille Replacement (Suburban, Tahoe) or Fascia Grille Replacement (Escalade) or Fascia Grille Replacement (Yukon) or Fascia Grille Replacement (GMC Yukon Two-mode Hybrid) .
  8. Fill and bleed the power steering system. Refer to Power Steering System Bleeding .
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.