Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Torque ADAPTOR Compensation
You must compensate for the torque wrench and the HPL crowfoot. Refer to the formula for compensation of the torque wrench. To obtain your dial reading perform the following procedure: Multiply your torque wrench length in inches by 225 ft. lbs. (305 Nm). Example for an 18" torque wrench: 18 X 225 = 4050. Add 3 to the length of your torque wrench. 18 + 3 = 21. Divide the first value obtained by the second value obtained. The result indicates the amount of torque your wrench should tighten the HPL solenoid to. 4050 divided by 21 = 192.8. For an 18" long torque wrench, tighten the HPL solenoid to 192.8 ft. lbs. (261.4 Nm).
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.