Front Seat Adjuster Memory Module Replacement

2008 Chevrolet Chevy Express G2500, Van Cargo, 6.6 6SECTION Front Seat Adjuster Memory Module Replacement
WARNING: This page is about a different car, the 2008 Cadillac CTS. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Front Seat Adjuster Memory Module Replacement
GM1969574Courtesy of GENERAL MOTORS CORP.
Callout Component Name
Preliminary Procedure:Β 
Remove the front seat. Refer to Front Seat Replacement - Bucket .
1 Front Seat Adjuster Memory Module

Procedure

  1. Disconnect the electrical connector.
  2. Unclip the module from the bracket and slide out through the bottom of the seat.
  3. Refer to Control Module References for programing and setup information.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.