SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2008CHEVY EXPRESS G2500, VAN CARGO, 6.6 6REPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 1438 (COMPONENT LOCATIONS & COMPONENT CONNECTOR END VIEWS)COMPONENT CONNECTOR END VIEWSPEDESTRIAN IMPACT DETECTION SENSOR - FRONT UPPER BEAM (B3T)
2008 Chevrolet Chevy Express G2500, Van Cargo, 6.6 6

Pedestrian Impact Detection Sensor - Front Upper Beam (B3T)

2008 Chevrolet Chevy Express G2500, Van Cargo, 6.6 6SECTION Pedestrian Impact Detection Sensor - Front Upper Beam (B3T)
WARNING: This page is about a different car, the 2008 Cadillac CTS. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Pedestrian Impact Detection Sensor - Front Upper Beam (B3T) Connector End View
GM810084Courtesy of GENERAL MOTORS CORP.
Pedestrian Impact Detection Sensor - Front Upper Beam (B3T)

Pin Wire Circuit Function
1 0.35 BK 407 Low Reference
2 0.35 YE 1834 Forward Discriminating Sensor Signal-03 Front End Sensor - Voltage
3 0.35 D-GN/WH 6620 Left Middle Side Impact Sensing Module Signal
4 0.35 GY 349 Discriminating Sensor - Left - Signal
Connector Part Information 
  • OEM: 1-967640-1
  • Service: 88953370
  • Description: 4-Way F MQS Socket Housing, Sealed (BK)
Terminal Part Information 
  • Terminal/Tray: 962885-5/15
  • Core/Insulation Crimp: 6/6
  • Release Tool/Test Probe: 12094429/J-35616-64B (L-BU)
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.