SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2008CHEVY EXPRESS G2500, VAN CARGO, 6.6 6REPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 1428 (ANTI-LOCK BRAKE SYSTEM, TRACTION CONTROL SYSTEM & STABILITY CONTROL SYSTEM)REPAIR INSTRUCTIONSFRONT WHEEL SPEED SENSOR REPLACEMENT (RWD)REMOVAL PROCEDURE
2008 Chevrolet Chevy Express G2500, Van Cargo, 6.6 6

Removal Procedure

2008 Chevrolet Chevy Express G2500, Van Cargo, 6.6 6SECTION Removal Procedure
WARNING: This page is about a different car, the 2008 Cadillac CTS. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION: Refer to Brake Dust Caution .
    Fig 1: Wheel Speed Sensor Electrical Connector
    GM1969787Courtesy of GENERAL MOTORS CORP.
  1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle .
  2. Remove the tire and wheel assembly. Refer to Tire and Wheel Removal and Installation .
  3. Remove the front bumper fascia lower closeout panel. Refer to Front Bumper Lower Fascia Replacement .
  4. Disconnect the wheel speed sensor electrical connector (1).
    5. Fig 2: Identifying Wheel Speed Sensor Wire Harness Clips
    GM1969794Courtesy of GENERAL MOTORS CORP.
  5. Remove the wheel speed sensor wire harness clips (1) from the vehicle frame.
    6. Fig 3: Identifying Wheel Speed Sensor Wire Harness Clip
    GM1969797Courtesy of GENERAL MOTORS CORP.
  6. Remove the wheel speed sensor wire harness clip (1) from the steering knuckle.
    7. Fig 4: Wheel Speed Sensor Bolt
    GM1969802Courtesy of GENERAL MOTORS CORP.
  7. Thoroughly clean the wheel speed sensor mounting area of the steering knuckle of any dirt and debris.
  8. Remove the wheel speed sensor bolt (1).
    9. Fig 5: Wheel Speed Sensor
    GM1969806Courtesy of GENERAL MOTORS CORP.
  9. Remove the wheel speed sensor (1) from the steering knuckle.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.