Power Mirror Replacement

2008 Chevrolet Chevy Express G2500, Van Cargo, 6.6 6SECTION Power Mirror Replacement
WARNING: This page is about a different car, the 2008 Cadillac CTS. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Power Mirror Replacement
GM1913769Courtesy of GENERAL MOTORS CORP.
Callout Component Name

Preliminary Procedures

  1. Remove the door trim panel. Refer to Front Side Door Trim Panel Replacement .
  2. Remove the front door upper trim. Refer to Front Side Door Garnish Molding Replacement .
1 Outside Rearview Power Mirror Harness Retainer
2 Outside Rearview Power Mirror Nuts (Qty: 3)
NOTE: Refer to Fastener Notice .

Procedure

  1. Lower the window to the full down position.
  2. Disconnect the power mirror wire harness electrical connector.

Tighten:Β  9 N.m (80 lb in)

3 Outside Rearview Power Mirror
Tip:Β  Pull the wiring harness through the hole in the mirror patch.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.