SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2008CHEVY EXPRESS G2500, VAN CARGO, 6.6 6REPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 1423 (BATTERY, CHARGING SYSTEM AND STARTING SYSTEM)REPAIR INSTRUCTIONSSTARTER SHIELD REPLACEMENT (LP1, LY7)REMOVAL PROCEDURE
2008 Chevrolet Chevy Express G2500, Van Cargo, 6.6 6

Removal Procedure

2008 Chevrolet Chevy Express G2500, Van Cargo, 6.6 6SECTION Removal Procedure
WARNING: This page is about a different car, the 2008 Cadillac CTS. However, it is still accessible from the selected car via links, so may be relevant.
  1. Disconnect the battery negative cable. Refer to Battery Negative Cable Disconnection and Connection (Side Post) .
  2. Remove the right catalytic converter. Refer to Catalytic Converter Replacement - Right Side .
    3. Fig 1: Aligning Starter Heat Shield To Starter Motor & Brackets
    GM772392Courtesy of GENERAL MOTORS CORP.
  3. Remove the fasteners securing the starter heat shield to the starter.
  4. Remove the starter heat shield.
    5. Fig 2: View Of Starter Heat Shield Mounting Bracket Retaining Nut
    GM772393Courtesy of GENERAL MOTORS CORP.
  5. Remove the nut securing the starter heat shield bracket to the starter.
  6. Remove the starter heat shield bracket.
    7. Fig 3: Locating Starter Heat Shield Mounting Bracket To Engine Block Retaining Nut
    GM847390Courtesy of GENERAL MOTORS CORP.
  7. Remove the nut securing the starter heat shield bracket to the engine block.
  8. Remove the starter heat shield bracket.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.