Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

SYS.OK|MANUAL.DB● LIVE

HOMESERVICE MANUALSCHEVROLET2008CHEVY EXPRESS G2500, VAN CARGO, 6.6 6REPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 1419 (WIPER SYSTEM & WASHER SYSTEM)REPAIR INSTRUCTIONSWINDSHIELD WASHER SOLVENT HEATER REPLACEMENT

2008 Chevrolet Chevy Express G2500, Van Cargo, 6.6 6

Windshield Washer Solvent Heater Replacement

2008 Chevrolet Chevy Express G2500, Van Cargo, 6.6 6SECTION Windshield Washer Solvent Heater Replacement

WARNING: This page is about a different car, the 2008 Cadillac CTS. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Windshield Washer Solvent Heater Replacement

Courtesy of GENERAL MOTORS CORP.

Callout	Component Name
Preliminary Procedures Open and support the hood. Remove the front compartment side sight shield on the passenger side of the engine compartment. Place a clean suitable container under the vehicle to contain any windshield washer fluid loss when the washer hoses are disconnected. Disconnect the 2 electrical connectors at the windshield washer solvent heater assembly.
1	Windshield Washer Solvent Heater Bracket Nut (Qty: 2) NOTE: Refer to Fastener Notice . Tighten: 9 N.m (80 lb in)
2	Windshield Washer Solvent Heater Assembly
3	Windshield Washer Solvent Hose Tip: Disconnect the hose and the windshield washer pump hose connection just below the windshield washer hose.

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready Tools Free Quote Check Quote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.