SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2008CHEVY EXPRESS G2500, VAN CARGO, 6.6 6REPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 1419 (WIPER SYSTEM & WASHER SYSTEM)REPAIR INSTRUCTIONSWINDSHIELD WASHER PUMP REPLACEMENT
2008 Chevrolet Chevy Express G2500, Van Cargo, 6.6 6

Windshield Washer Pump Replacement

2008 Chevrolet Chevy Express G2500, Van Cargo, 6.6 6SECTION Windshield Washer Pump Replacement
WARNING: This page is about a different car, the 2008 Cadillac CTS. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Windshield Washer Pump Replacement
GM1963055Courtesy of GENERAL MOTORS CORP.
Callout Component Name
Preliminary Procedure: 
Remove the right front wheelhouse extension. Refer to Wheelhouse Extension Replacement .
1 Windshield Washer Hose

Procedure

  1. Place a clean suitable clean container under the washer container to secure spillage when removing the pump from the windshield washer solvent container.
  2. Remove the washer hose from the washer pump spout.
  3. Disconnect the electrical connection at the windshield washer pump.
2 Windshield Washer Pump

Procedure

  1. Using two flat-bladed tools placed under the pump, gently pry upward in order to release the pump from the container grommet.
  2. Release and remove the pump and contain the windshield washer solvent.
  3. Discard the old windshield washer pump grommet.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.