Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DBβ LIVE
HOMESERVICE MANUALSCHEVROLET2008CHEVY EXPRESS G2500, VAN CARGO, 6.6 6REPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 1419 (WIPER SYSTEM & WASHER SYSTEM)DIAGNOSTIC INFORMATION AND PROCEDURESWASHER MALFUNCTIONCOMPONENT TESTING
2008 Chevrolet Chevy Express G2500, Van Cargo, 6.6 6
Component Testing
2008 Chevrolet Chevy Express G2500, Van Cargo, 6.6 6SECTION Component Testing
WARNING: This page is about a different car, the 2008 Cadillac CTS. However, it is still accessible from the selected car via links, so may be relevant.
Multifunction Switch
- With the ignition OFF, disconnect the X1 harness connector at the turn signal/multifunction switch.
- Test the resistance between terminals H and L. Rotate the wiper switch and compare the resistance readings to the values in the Windshield Wiper Switch Values table below for MIST, each DELAY and LOW speed.
- If the resistance is not within the specified range, replace the turn signal/multifunction switch.
- Test for infinite resistance between terminals H and K while rotating the wiper switch to MIST, each DELAY and LOW speed positions.
- If the less than infinite, replace the turn signal/multifunction switch.
- Test for less than 5 ohms of resistance with the wiper switch in the High speed position.
- If greater than 5 ohms, replace the turn signal/multifunction switch.
- Test for infinite resistance between terminals H and J while rotating the wiper switch to MIST, each DELAY and LOW speed positions.
- If less than infinite, replace the turn signal/multifunction switch.
- Test for less than 5 ohms of resistance while pressing the WASHER switch.
- If greater than 5 ohms, replace the turn signal/multifunction switch.
IMPORTANT:
If the switch tests open in any switch position other than Off, test the wiper/washer switch signal circuits for a short to voltage before replacing the switch.
Wiper Switch Values
| Switch Position | Resistance |
|---|---|
| Off | Infinite |
| Mist | 300-364 Ξ© |
| Delay 1 | 3.48K-4.25K Ξ© |
| Delay 2 | 2.52K-3.08K Ξ© |
| Delay 3 | 1.78K-2.18K Ξ© |
| Delay 4 | 1.17K-1.44K Ξ© |
| Delay 5 | 697-851 Ξ© |
| Low | 2.52K-3.08K Ξ© |
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.