Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2008CHEVY EXPRESS G2500, VAN CARGO, 6.6 6REPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 141 (ENGINE CONTROLS - BASIC DIAGNOSTIC PROCEDURES)IGNITION SYSTEMSELECTRONIC IGNITION SYSTEM DIAGNOSISTEST DESCRIPTION
2008 Chevrolet Chevy Express G2500, Van Cargo, 6.6 6
Test Description
2008 Chevrolet Chevy Express G2500, Van Cargo, 6.6 6SECTION Test Description
WARNING: This page is about a different car, the 2003 Cadillac Seville and 2003 Cadillac DeVille. However, it is still accessible from the selected car via links, so may be relevant.
The numbers below refer to the numbers in the diagnostic procedure.
- 3
This step tests for a short to battery positive voltage on the ignition 1 voltage circuit. When the ignition is turned OFF, the test light should not illuminate at the COIL/MDL fuse. - 18
The Spark Tester places a higher load, up to 25,000 volts, on the secondary ignition than a normal spark plug.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.