Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2008CHEVY EXPRESS G2500, VAN CARGO, 6.6 6REPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 1409 (CELLULAR SYSTEM, ENTERTAINMENT SYSTEM, AND NAVIGATION SYSTEM)DIAGNOSTIC INFORMATION AND PROCEDURESDTC B1283-B1286CIRCUIT/SYSTEM TESTING
2008 Chevrolet Chevy Express G2500, Van Cargo, 6.6 6
Circuit/System Testing
2008 Chevrolet Chevy Express G2500, Van Cargo, 6.6 6SECTION Circuit/System Testing
WARNING: This page is about a different car, the 2008 Cadillac CTS. However, it is still accessible from the selected car via links, so may be relevant.
- Ignition OFF, disconnect the appropriate antenna harness connector at the TV antenna module and the harness connector at the TV antenna amplifier.
- Test for less than 5 ohms of resistance between the two ends of the coax cable center conductor.
- If greater than the specified range, replace the antenna coax cable.
- Test for less than 5 ohms of resistance between the two ends of the coax cable outer shield.
- If greater than the specified range, replace the antenna coax able.
- Test for infinite resistance between the antenna coax center conductor and the outer shield.
- If less than the specified range, replace the antenna coax cable.
- Connect the harness connector at the TV antenna module.
- Ignition ON, TV ON, wait 20 seconds, test for more than 1 volt at the coax cable center conductor terminal 2.
- If less than the specified value, replace the TV antenna module.
- Ignition OFF, disconnect the harness connector at the appropriate TV antenna.
- Test for less than 5 ohms of resistance between the two ends of the TV antenna coax cable center conductor.
- If greater than the specified range, replace the TV antenna coax cable.
- Test for less than 5 ohms of resistance between the two ends of the TV antenna coax cable outer shield.
- If greater than the specified range, replace the TV antenna coax able.
- Test for infinite resistance between the TV antenna coax center conductor and the outer shield.
- If less than the specified range, replace the TV antenna coax cable.
- Ignition OFF, TV OFF, connect the harness connector at the TV antenna amplifier.
- Ignition ON, TV ON, wait 20 seconds, test for more than 1 volt at the TV antenna coax cable center conductors.
- If less than the specified value, replace the TV antenna amplifier.
- If all circuits test normal, replace the inoperative TV antenna.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.