SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2008CHEVY EXPRESS G2500, VAN CARGO, 6.6 6REPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 1401 (LIGHTING SYSTEMS)REPAIR INSTRUCTIONSPARK/TURN SIGNAL LAMP BULB REPLACEMENT (BASE)
2008 Chevrolet Chevy Express G2500, Van Cargo, 6.6 6

Park/Turn Signal Lamp Bulb Replacement (Base)

2008 Chevrolet Chevy Express G2500, Van Cargo, 6.6 6SECTION Park/Turn Signal Lamp Bulb Replacement (Base)
WARNING: This page is about a different car, the 2008 Cadillac CTS. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Park/Turn Signal Lamp Bulb Replacement (Base)
GM1963013Courtesy of GENERAL MOTORS CORP.
Callout Component Name
Preliminary Procedure: 
Remove the headlamp capsule. Refer to Headlamp Capsule Replacement .
1 Accessory Cap Screw (Qty: 3)
Tip:  Hand tighten only, the accessory cap screws.
2 Accessory Cap
Tip:  Inspect and ensure the accessory cap seal is properly seated prior to installing the accessory cap cover.
3 Turn Signal Lamp Bulb
CAUTION: Refer to Halogen Bulb Caution .

Procedure

  1. Pinch the tabs on the bulb socket and pull the bulb socket from the headlamp assembly.
  2. Disconnect the electrical connector from the bulb socket.
  3. Remove and replace the bulb.
4 Park Signal Lamp Bulb

Procedure

  1. Pinch the tabs on the bulb socket and pull the bulb socket from the headlamp assembly.
  2. Disconnect the electrical connector from the bulb socket.
  3. Remove and replace the bulb.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.