SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2008CHEVY EXPRESS G2500, VAN CARGO, 6.6 6REPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 1401 (LIGHTING SYSTEMS)REPAIR INSTRUCTIONSFRONT SIDE TURN SIGNAL LAMP REPLACEMENT
2008 Chevrolet Chevy Express G2500, Van Cargo, 6.6 6

Front Side Turn Signal Lamp Replacement

2008 Chevrolet Chevy Express G2500, Van Cargo, 6.6 6SECTION Front Side Turn Signal Lamp Replacement
WARNING: This page is about a different car, the 2008 Cadillac CTS. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Front Side Turn Signal Lamp Replacement
GM1912957Courtesy of GENERAL MOTORS CORP.
Callout Component Name
Preliminary Procedure: 
Apply two layers of masking tape to the rear edge of the lamp assembly in order to protect the painted surface when removing the lamp from the fender.
1 Front Side Turn Signal Lamp

Procedure

  1. Using a small flat-bladed tool, depress the locking tab at the rear edge of the turn signal lamp assembly.
  2. Pull the lamp outward away from the fender.
  3. Disconnect the electrical connector to remove the lamp assembly.
  4. Rotate the bulb socket from the lamp.
  5. Replace the bulb as needed.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.