Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2008CHEVY EXPRESS G2500, VAN CARGO, 6.6 6REPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 1400 (BUMPER SYSTEM & FASCIA)SPECIFICATIONSFASTENER TIGHTENING SPECIFICATIONS
2008 Chevrolet Chevy Express G2500, Van Cargo, 6.6 6
Fastener Tightening Specifications
2008 Chevrolet Chevy Express G2500, Van Cargo, 6.6 6SECTION Fastener Tightening Specifications
WARNING: This page is about a different car, the 2008 Cadillac CTS. However, it is still accessible from the selected car via links, so may be relevant.
| Application | Specification | |
|---|---|---|
| Metric | English | |
| Front Bumper Fascia Lower Closeout Panel Screws | 3 N.m | 27 lb in |
| Front Energy Absorber Nuts | 25 N.m | 18 lb ft |
| Front Impact Bar Bolts | 25 N.m | 18 lb ft |
| Inner Fender Bolts | 9 N.m | 80 lb in |
| Inner Fender Nuts | 9 N.m | 80 lb in |
| Rear Bumper Bracket Bolts | 3 N.m | 27 lb in |
| Rear Energy Absorber Bolts | 25 N.m | 18 lb ft |
| Rear Energy Nuts | 25 N.m | 18 lb ft |
| Rear Fascia Bolts | 3 N.m | 27 lb in |
| Rear Fascia Extension Screws | 6 N.m | 53 lb in |
| Rear Fascia Nuts | 6 N.m | 53 lb in |
| Rear Impact Bar Bolts | 25 N.m | 18 lb ft |
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.