Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2008CHEVY EXPRESS G2500, VAN CARGO, 6.6 6REPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 1355 (SUSPENSION CONTROL SYSTEM - AUTOMATIC LEVEL CONTROL)DIAGNOSTIC INFORMATION AND PROCEDURESAUTOMATIC LEVEL CONTROL SYSTEM LEAK TESTTOOLS REQUIRED
2008 Chevrolet Chevy Express G2500, Van Cargo, 6.6 6
Tools Required
2008 Chevrolet Chevy Express G2500, Van Cargo, 6.6 6SECTION Tools Required
WARNING: This page is about a different car, the 2008 Cadillac STS. However, it is still accessible from the selected car via links, so may be relevant.
J 22124-B Pressure Gage (0-300 psi)
- Disconnect the air tube from the air dryer.
- Attach the air tube to the J 22124-B pressure gage on the side opposite the toggle valve.
- Close the toggle valve.
- Apply service air pressure to the service valve and pressurize until the J 22124-B pressure gage reads 550 kPa (80 psi).
- Verify that the system maintains pressure for at least 1 minute.
- If the system does not maintain the specified pressure for the specified amount of time, check the shock absorber air sleeves, air tubes, and all connections for air leaks using a soapy water solution. Repair or replace any leaking components. Refer to Air Tube Replacement and Shock Absorber Replacement .
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.