Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2008CHEVY EXPRESS G2500, VAN CARGO, 6.6 6REPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 1342 (POWER STEERING SYSTEM)SPECIFICATIONSFASTENER TIGHTENING SPECIFICATIONS
2008 Chevrolet Chevy Express G2500, Van Cargo, 6.6 6
Fastener Tightening Specifications
2008 Chevrolet Chevy Express G2500, Van Cargo, 6.6 6SECTION Fastener Tightening Specifications
WARNING: This page is about a different car, the 2008 Cadillac STS. However, it is still accessible from the selected car via links, so may be relevant.
| Application | Specification | |
|---|---|---|
| Metric | English | |
| Air Cleaner Assembly front half screws | 8 N.m | 71 lb in |
| Brake Line to Brake Hose Fitting | 27 N.m | 20 lb ft |
| Intermediate Steering Shaft Pinch Bolt | 50 N.m | 37 lb ft |
| Lower Engine Mount Nuts to Frame | 80 N.m | 59 lb ft |
| Outer Tie Rod to Knuckle Retaining Nut | 70 N.m | 52 lb ft |
| Power Steering Cooler Pipe/Hose to Frame Retaining Bolt | 10 N.m | 88 lb in |
| Power Steering Cooler to Bracket Retaining Bolts | 9 N.m | 80 lb in |
| Power Steering Gear Retaining Bolts | 180 N.m | 134 lb ft |
| Power Steering Hoses to Power Steering Gear Retaining Bolt | 23 N.m | 17 lb ft |
| Power Steering Pressure Hose to Frame Retaining Bolts | 10 N.m | 88 lb in |
| Power Steering Pressure Hose to Power Steering Pump | 40 N.m | 30 lb ft |
| Power Steering Pump Bracket to Engine Bolt | 50 N.m | 37 lb ft |
| Power Steering Pump to Engine Bolt | 50 N.m | 37 lb ft |
| Power Steering Pump to Power Steering Bracket Bolt | 25 N.m | 18 lb ft |
| Power Steering Reservoir Retaining Nuts | 9 N.m | 80 lb in |
| Power Steering Return Line to Frame Retaining Bolt. | 10 N.m | 88 lb in |
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.