SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2008CHEVY EXPRESS G2500, VAN CARGO, 6.6 6REPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 1340 (CRUISE CONTROL SYSTEM)REPAIR INSTRUCTIONSDISTANCE SENSING CRUISE CONTROL MODULE REPLACEMENT
2008 Chevrolet Chevy Express G2500, Van Cargo, 6.6 6

Distance Sensing Cruise Control Module Replacement

2008 Chevrolet Chevy Express G2500, Van Cargo, 6.6 6SECTION Distance Sensing Cruise Control Module Replacement
WARNING: This page is about a different car, the 2008 Cadillac STS. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: View Of Distance Sensing Cruise Control Module
GM1488807Courtesy of GENERAL MOTORS CORP.
Callout Component Name
1 Front Compartment Sight Shield Retainer (Qty: 6)
2 Front Compartment Sight Shield Assembly
Tip:  The center sight shield needs to be removed, the side sight shields only need to be loosened.
3 Front Fascia Assembly Retainer (Qty: 4)
Tip: 
  1. Remove the 4 retainers to loosen the fascia assembly.
  2. Pull the front fascia assembly forward to gain access to the cruise control module nuts.
4 Cruise Control Module Assembly
NOTE: Refer to Fastener Notice

Tip: 
  1. Loosen the nuts that hold the cruise control module into the T-slots on the tie bar.
  2. Disconnect the electrical connector.
  3. Slide the module out of the T-slots on the bracket.
  4. Replace the module by sliding the assembly into the T-slots on the bracket and tighten.
  5. Verify proper alignment of the module. Refer to Control Module References for programming and setup information.

Tighten:  9 N.m (80 lb in)
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.