Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

SYS.OK|MANUAL.DB● LIVE

HOMESERVICE MANUALSCHEVROLET2008CHEVY EXPRESS G2500, VAN CARGO, 6.6 6REPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 1336 (SUNROOF SYSTEM)REPAIR INSTRUCTIONSSUNROOF AIR DEFLECTOR REPLACEMENTINSTALLATION PROCEDURE

2008 Chevrolet Chevy Express G2500, Van Cargo, 6.6 6

Installation Procedure

2008 Chevrolet Chevy Express G2500, Van Cargo, 6.6 6SECTION Installation Procedure

WARNING: This page is about a different car, the 2008 Cadillac STS. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: View of Air Deflector, Sunroof Module, & Side Hooks

Courtesy of GENERAL MOTORS CORP.

Engage the rear of the air deflector (1) into the side hooks (2) on the sunroof module (3).
Position the air deflector forward.
Push the right side of the air deflector down into the roof opening.

Fig 2: View of Lower Tab & Roof Opening

Courtesy of GENERAL MOTORS CORP.

While holding the right side down, complete the following steps:
1. Push the left front side of the air deflector towards the right side.
2. Pull up on the left side until the lower tab (1) clears the roof opening.

Fig 3: View of Air Deflector

Courtesy of GENERAL MOTORS CORP.

Push the left front side of the air deflector inwards and down so the tab clears the roof opening.
Close the sunroof window.

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready Tools Free Quote Check Quote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.