Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Circuit/System Description
Proper operation of the Vehicle Stability Enhancement System (VSES) is highly dependent on the ability to apply brake pressure to a selected wheel, through the brake pressure modulator valve (BPMV), as commanded by the electronic brake control module (EBCM). The EBCM may not be able to detect certain mechanical failures that may cause the VSES to perform poorly. This diagnostic procedure is designed to help diagnose concerns of poor vehicle stability that may occur without the presence of any DTCs, by verifying the following:
- The tires are the correct size, properly inflated and in acceptable condition.
- There are no mechanical problems in the steering system.
- There are no mechanical problems in the suspension system.
- There are no mechanical problems in the base brake system.
- There are no mechanical problems in the locking differential or transfer case.
- All of the VSES related hydraulic controls within the BPMV are functioning correctly.
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.