Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2008CHEVY EXPRESS G2500, VAN CARGO, 6.6 6REPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 1335 (ANTI-LOCK BRAKE SYSTEM, TRACTION CONTROL SYSTEM & STABILITY CONTROL SYSTEM)DIAGNOSTIC INFORMATION AND PROCEDURESDTC C0161CONDITIONS FOR SETTING THE DTC
2008 Chevrolet Chevy Express G2500, Van Cargo, 6.6 6
Conditions for Setting the DTC
2008 Chevrolet Chevy Express G2500, Van Cargo, 6.6 6SECTION Conditions for Setting the DTC
WARNING: This page is about a different car, the 2008 Cadillac STS. However, it is still accessible from the selected car via links, so may be relevant.
- The brake pedal is sensed as applied.
- The vehicle speed is greater than 40 km/h (25 mph).
- The vehicles acceleration exceeds 8 km/h per second (5 mph per second).
- Brake pedal is not applied.
- Master cylinder pressure is greater than 150 psi.
- The vehicle speed is greater than 24 km/h (14 mph).
- The vehicles deceleration exceeds 11.5 km/h per second (7 mph per second).
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.