Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2008CHEVY EXPRESS G2500, VAN CARGO, 6.6 6REPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 1324 (DISC BRAKE SYSTEM)SPECIFICATIONSFASTENER TIGHTENING SPECIFICATIONS
2008 Chevrolet Chevy Express G2500, Van Cargo, 6.6 6
Fastener Tightening Specifications
2008 Chevrolet Chevy Express G2500, Van Cargo, 6.6 6SECTION Fastener Tightening Specifications
WARNING: This page is about a different car, the 2008 Cadillac STS. However, it is still accessible from the selected car via links, so may be relevant.
| Application | Specification | |
|---|---|---|
| Metric | English | |
| Brake Caliper Bleeder Valve | 14 N.m | 124 lb in |
| Brake Caliper Bolt - Front (J56) | 130 N.m | 96 lb ft |
| Brake Caliper Bolt - Rear (J56) | 120 N.m | 88 lb ft |
| Brake Hose Fitting Bolt - Front and Rear (JE5, JL9) | 50 N.m | 37 lb ft |
| Brake Hose Fitting Bolt - Front and Rear (J56) | 34 N.m | 25 lb ft |
| Brake Pipe Fitting Nut | 18 N.m | 13 lb ft |
| Brake Rotor Screw | 14 N.m | 124 lb in |
| Front Brake Caliper Bracket Bolt (JE5, JL9) | 130 N.m | 96 lb ft |
| Front Brake Caliper Pin Bolt (JE5) | 34 N.m | 25 lb ft |
| Front Brake Caliper Pin Bolt (JL9) | 63 N.m | 46 lb ft |
| Rear Brake Caliper Bracket Bolt (JE5, JL9) | 120 N.m | 88 lb ft |
| Rear Brake Caliper Pin Bolt (JE5, JL9) | 60 N.m | 44 lb ft |
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.