SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2008CHEVY EXPRESS G2500, VAN CARGO, 6.6 6REPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 1319 (FRONT SUSPENSION SYSTEM)REPAIR INSTRUCTIONSSHOCK MODULE YOKE REPLACEMENT (RWD)INSTALLATION PROCEDURE
2008 Chevrolet Chevy Express G2500, Van Cargo, 6.6 6

Installation Procedure

2008 Chevrolet Chevy Express G2500, Van Cargo, 6.6 6SECTION Installation Procedure
WARNING: This page is about a different car, the 2008 Cadillac STS. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Yoke To Lower Control Arm Bolt
    GM1689969Courtesy of GENERAL MOTORS CORP.
  1. Position the yoke (2) to the shock and control arm.
    2. NOTE: Refer to Fastener Notice .
  2. Install the yoke to control arm bolt (1).

    Tighten:  Tighten the bolt to 180 N.m (133 lb ft).

    3. Fig 2: Shock To Yoke Retaining Nut & Bolt
    GM1689967Courtesy of GENERAL MOTORS CORP.
  3. Install the shock to yoke retaining bolt (2).
  4. Install the shock yoke nut (1).

    Tighten:  Tighten the nut to 90 N.m (66 lb ft).

  5. Install the tire and wheel. Refer to Tire and Wheel Removal and Installation .
  6. Lower the vehicle.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.