Installation Procedure

2008 Chevrolet Chevy Express G2500, Van Cargo, 6.6 6SECTION Installation Procedure
WARNING: This page is about a different car, the 2008 Cadillac STS. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Washer Hose Assembly
    GM1233321Courtesy of GENERAL MOTORS CORP.
  1. Position the washer hose assembly to the vehicle.
  2. Secure the washer hose clips to the electrical main body harness.
  3. Secure the headlamp washer hose quick connects to both headlamp washer nozzles.
  4. Fig 2: View Of Headlamp Washer Hose Quick Connect
    GM786882Courtesy of GENERAL MOTORS CORP.
  5. Secure the washer hose quick connect to the headlamp washer pump nozzle (1).
  6. Install the left front headlamp.
  7. Install the radiator support sight shield.
  8. Install the front air deflector. Refer to Front Air Deflector Replacement .
  9. Fill the reservoir with washer solvent.
  10. Verify the operation of the headlamp washers.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.