SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2008CHEVY EXPRESS G2500, VAN CARGO, 6.6 6REPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 1240 (HYDRAULIC BRAKE SYSTEM)REPAIR INSTRUCTIONSBRAKE FLUID LEVEL INDICATOR SWITCH REPLACEMENTINSTALLATION PROCEDURE
2008 Chevrolet Chevy Express G2500, Van Cargo, 6.6 6

Installation Procedure

2008 Chevrolet Chevy Express G2500, Van Cargo, 6.6 6SECTION Installation Procedure
WARNING: This page is about a different car, the 2008 Chevrolet Malibu Classic. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Brake Fluid Level Sensor
    GM1226077Courtesy of GENERAL MOTORS CORP.
  1. Align the brake fluid level sensor to the master cylinder reservoir.
  2. Press the brake fluid level sensor into the master cylinder reservoir, ensure the retaining tabs click into place.
    3. Fig 2: Identifying Brake Fluid Level Sensor Connector
    GM1226007Courtesy of GENERAL MOTORS CORP.
  3. Connect the electrical connector to the brake fluid level sensor.
    4. Fig 3: View Of Master Cylinder Mounting Nuts
    GM1219209Courtesy of GENERAL MOTORS CORP.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.