Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

SYS.OK|MANUAL.DB● LIVE

HOMESERVICE MANUALSCHEVROLET2008CHEVY EXPRESS G2500, VAN CARGO, 6.6 6REPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 1229 (SUPPLEMENTAL INFLATABLE RESTRAINT SYSTEM)REPAIR INSTRUCTIONSINFLATABLE RESTRAINT SIDE IMPACT MODULE REPLACEMENT - FRONTINSTALLATION PROCEDURE

2008 Chevrolet Chevy Express G2500, Van Cargo, 6.6 6

Installation Procedure

2008 Chevrolet Chevy Express G2500, Van Cargo, 6.6 6SECTION Installation Procedure

WARNING: This page is about a different car, the 2008 Chevrolet Malibu Classic. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: View Of Inflatable Restraint Side Impact Module Electrical Connector

Courtesy of GENERAL MOTORS CORP.

Connect the electrical connector (1) to the inflatable restraint side impact module.
Install the CPA to the module electrical connector.

Fig 2: Identifying Inflatable Restraint Side Impact Module

Courtesy of GENERAL MOTORS CORP.

Install the inflatable restraint side impact module to the seat.
Install the nuts to the inflatable restraint side impact module.
Tighten: Tighten the bolts to 10 N.m (89 lb in).

Fig 3: View Of Seat Back Panel

Courtesy of GENERAL MOTORS CORP.

Install the seat back panel. Refer to Driver Seat and Passenger Seat Back Cushion Finish Panel Replacement .
Enable the SIR system. Refer to SIR Disabling and Enabling .
Fully deploy the module before disposal. If the module was replaced under warranty, fully deploy and dispose of the module after the required retention period. Refer to Inflator Module Handling and Scrapping .

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready Tools Free Quote Check Quote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.