Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

SYS.OK|MANUAL.DB● LIVE

HOMESERVICE MANUALSCHEVROLET2008CHEVY EXPRESS G2500, VAN CARGO, 6.6 6REPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 1224 (LIGHTING SYSTEMS)REPAIR INSTRUCTIONSTAIL LAMP ASSEMBLY AND /OR BACKUP, SIDEMARKER, STOP, TURN SIGNAL BULB REPLACEMENT (SEDAN)REMOVAL PROCEDURE

2008 Chevrolet Chevy Express G2500, Van Cargo, 6.6 6

Removal Procedure

2008 Chevrolet Chevy Express G2500, Van Cargo, 6.6 6SECTION Removal Procedure

WARNING: This page is about a different car, the 2008 Chevrolet Malibu Classic. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: View Of Tail Lamp Screws

Courtesy of GENERAL MOTORS CORP.

Open the rear compartment.
Remove the screws from the tail lamp.
From the inside of the rear compartment, pull back the side trim panel. Remove the wing nut from the tail lamp.
Pull the tail lamp rearward to disengage the tail lamp from the quarter panel.

Fig 2: Identifying Electrical Connector And Tail Lamp Wiring Harness

Courtesy of GENERAL MOTORS CORP.

Disconnect the electrical connector from the tail lamp wiring harness.
Remove the tail lamp, stoplamp, and backup lamp sockets by rotating the sockets counterclockwise.
Remove the bulbs from the tail lamp, stop lamp, and/or backup lamp sockets.

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready Tools Free Quote Check Quote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.