Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

SYS.OK|MANUAL.DB● LIVE

HOMESERVICE MANUALSCHEVROLET2008CHEVY EXPRESS G2500, VAN CARGO, 6.6 6REPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 1224 (LIGHTING SYSTEMS)REPAIR INSTRUCTIONSREAR LICENSE LAMP REPLACEMENT (SEDAN)REMOVAL PROCEDURE

2008 Chevrolet Chevy Express G2500, Van Cargo, 6.6 6

Removal Procedure

2008 Chevrolet Chevy Express G2500, Van Cargo, 6.6 6SECTION Removal Procedure

WARNING: This page is about a different car, the 2008 Chevrolet Malibu Classic. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: View Of Rear Compartment Lid

Courtesy of GENERAL MOTORS CORP.

Remove the 3 center screws from the rear compartment lid applique. Refer to Rear Compartment Lid Applique Replacement .
Open the rear compartment lid.
From the underside of the rear compartment lid, push in the side retaining tabs to the license lamp to unseat the lamp from the rear compartment lid.

Fig 2: View Of License Lamp

Courtesy of GENERAL MOTORS CORP.

From the outside of the rear compartment lid, carefully lift the rear compartment lid applique away from the rear compartment lid. Allow enough clearance for removal of the license lamp.
Remove the license lamp.
Disconnect the electrical connector.
Remove the bulb/socket from the license lamp by rotating the socket counterclockwise.
Remove the license lamp bulb from the socket, if required.

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready Tools Free Quote Check Quote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.