Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

SYS.OK|MANUAL.DB● LIVE

HOMESERVICE MANUALSCHEVROLET2008CHEVY EXPRESS G2500, VAN CARGO, 6.6 6REPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 1224 (LIGHTING SYSTEMS)REPAIR INSTRUCTIONSFRONT FOG LAMP REPLACEMENT (BASE)REMOVAL PROCEDURE

2008 Chevrolet Chevy Express G2500, Van Cargo, 6.6 6

Removal Procedure

2008 Chevrolet Chevy Express G2500, Van Cargo, 6.6 6SECTION Removal Procedure

WARNING: This page is about a different car, the 2008 Chevrolet Malibu Classic. However, it is still accessible from the selected car via links, so may be relevant.

Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle .

Fig 1: View Of Electrical Connector And Front Fog Lamp Assembly

GM1326365

Courtesy of GENERAL MOTORS CORP.

Disconnect the electrical connector from the front fog lamp assembly.
Twist the bulb about 1/4 turn counterclockwise.

Fig 2: View Of Fog Lamp Bulb And Lamp Housing

GM1215798

Courtesy of GENERAL MOTORS CORP.

Remove the fog lamp bulb from the lamp housing.

Fig 3: View Of Nuts Mounting Front Fog Lamp Assembly To Lower Grille

GM1217685

Courtesy of GENERAL MOTORS CORP.

Remove the nuts mounting the front fog lamp assembly to the lower grille.

Fig 4: View Of Fog Lamp Assembly And Lower Grille

GM1217686

Courtesy of GENERAL MOTORS CORP.

Remove the fog lamp assembly from the lower grille.

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready Tools Free Quote Check Quote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.