Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2008CHEVY EXPRESS G2500, VAN CARGO, 6.6 6REPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 1160 (ENGINE CONTROLS AND FUEL - 6.6L - INTRODUCTION (2 OF 2))REPAIR INSTRUCTIONSEXHAUST GAS RECIRCULATION VALVE TEMPERATURE SENSOR REPLACEMENT - POSITION 1
2008 Chevrolet Chevy Express G2500, Van Cargo, 6.6 6
Exhaust Gas Recirculation Valve Temperature Sensor Replacement - Position 1
2008 Chevrolet Chevy Express G2500, Van Cargo, 6.6 6SECTION Exhaust Gas Recirculation Valve Temperature Sensor Replacement - Position 1
WARNING: This page is about a different car, the 2008 GMC Sierra, 2008 GMC Cab & Chassis Sierra, 2008 Chevrolet Silverado, and 2008 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
| Callout | Component Name |
|---|---|
|
|
| 1 | EGR Temperature Sensor Assembly
NOTE:
Refer to Fastener Notice
.
Tighten: 44 N.m (32 lb ft) Procedure
|
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.