Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2008CHEVY EXPRESS G2500, VAN CARGO, 6.6 6REPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 1158 (POWER SEAT SYSTEM)DIAGNOSTIC INFORMATION AND PROCEDURESMEMORY SEAT FEATURE INOPERATIVECIRCUIT/SYSTEM TESTING
2008 Chevrolet Chevy Express G2500, Van Cargo, 6.6 6
Circuit/System Testing
2008 Chevrolet Chevy Express G2500, Van Cargo, 6.6 6SECTION Circuit/System Testing
WARNING: This page is about a different car, the 2008 GMC Sierra, 2008 GMC Cab & Chassis Sierra, 2008 Chevrolet Silverado, and 2008 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
- Ignition ON, verify the scan tool Memory Recall Switches parameter is approximately 2.74 volts while pressing the memory 1 switch.
- If the parameter is not the specified value, refer to Memory Switch component test below. If the switch tests normal, replace the driver door switch.
- Verify the scan tool Memory Recall Switches parameter is approximately 1.78 volts while pressing the memory 2 switch.
- If the parameter is not the specified value, replace the memory switch.
- Verify the scan tool Memory Recall Switches parameter is approximately 0.96 volt while pressing the EXIT switch.
- If the parameter is not the specified value, replace the memory switch.
- If all circuits test normal, replace the memory seat module.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.