Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2008CHEVY EXPRESS G2500, VAN CARGO, 6.6 6REPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 113 (AUTOMATIC TRANSMISSION SERVICING (4L60-E))TORQUE SPECIFICATIONS
2008 Chevrolet Chevy Express G2500, Van Cargo, 6.6 6
Torque Specifications
2008 Chevrolet Chevy Express G2500, Van Cargo, 6.6 6SECTION Torque Specifications
WARNING: This page is about a different car, the 2003 GMC Savana and 2003 Chevrolet Chevy Express. However, it is still accessible from the selected car via links, so may be relevant.
TORQUE SPECIFICATIONS
| Application | Ft. Lbs. (N.m) | ||
|---|---|---|---|
| Auxiliary Oil Cooler Line | 17 (23) | ||
| Flair Nuts | 33 (45) | ||
| Forward Servo Cover Bolt | 18 (24) | ||
| Heat Shield Retaining Bolts | 13 (18) | ||
| Oil Pan Drain Plug | 13 (18) | ||
| Park Neutral Position Switch Bolt | 18 (24) | ||
| Reverse Servo Cover Bolt | 18 (24) | ||
| Transmission Control Lever Nut | 18 (24) | ||
| Upper Cooler Line-To-Radiator Flair Nut | 33 (45) | ||
| INCH Lbs. (N.m) | |||
| Accumulator-To-Case Bolt | 97 (11) | ||
| Auxiliary Oil Cooler Support Bolts | 89 (10) | ||
| Control Valve Body Bolts | 97 (11) | ||
| Filler Tube Bolt | 53 (6) | ||
| Fluid Pressure Switch | 97 (11) | ||
| Manual Detent Spring Bolt | 97 (11) | ||
| Manual Valve Position Switch Bolts | 97 (11) | ||
| Oil Pan Bolt | 97 (11) | ||
| Oil Pass Cover Bolt | 97 (11) | ||
| Pressure Control Solenoid Bolt | 97 (11) | ||
| Spacer Plate Support Retaining Bolt | 97 (11) | ||
| TCC Solenoid Bolt | 97 (11) | ||
| Transmission Fluid Indicator Stop Bolt | 97 (11) | ||
| Valve Body-To-Case Bolt (1) | 97 (11) | ||
| VSS Bolt | 97 (11) | ||
|
|||
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.