Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2008CHEVY EXPRESS G2500, VAN CARGO, 6.6 6REPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 1076 (ENGINE CONTROLS AND FUEL - 6.6L (LMM) - DTC P154B TO DTC P2693)DTC P244BCIRCUIT/SYSTEM VERIFICATION
2008 Chevrolet Chevy Express G2500, Van Cargo, 6.6 6
Circuit/System Verification
2008 Chevrolet Chevy Express G2500, Van Cargo, 6.6 6SECTION Circuit/System Verification
WARNING: This page is about a different car, the 2007 GMC Sierra, 2007 GMC Cab & Chassis Sierra, 2007 Chevrolet Silverado, and 2007 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
- Verify that DTCs P003A, P0047, P0048, P0101, P0201-P0208, P02A1, P02A5, P02A9, P02AD, P02B1, P02B5, P02B9, P02E0, P02E7-P02E9, P029D, P0234, P0299, P0300-P0308, P0401, P0402, P046C, P0545, P0546, P0698, P0699, P2032, P2033, P2453, or P2563 are not set.
- If any of the DTCs are set, refer to Diagnostic Trouble Code (DTC) List - Vehicle .
- Verify the following scan tool parameters:
- Engine Run Time Since Last DPF Regeneration parameter-The value should be less than 22 hours.
- Fuel Used Since Last DPF Regeneration parameter-The value should be less than 272 liters (71 gallons).
- Distance Since Last DPF Regeneration parameter-The value should be less than 1,030 kilometers (640 miles) at sea level, or less than 772 kilometers (480 miles) when equal to or above 5,000 feet altitude.
- If any of the parameters are greater than the specified range, perform a DPF Service Regeneration. Refer to Exhaust Particulate Filter Cleaning (DPF Service Regeneration) or Exhaust Particulate Filter Cleaning (DPF Regeneration Enable) .
- Operate the vehicle within the Conditions for Running the DTC. You may also operate the vehicle within the conditions that you observed from the Freeze Frame Records data.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.