Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2008CHEVY EXPRESS G2500, VAN CARGO, 6.6 6REPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 1001 (CELLULAR SYSTEM, ENTERTAINMENT SYSTEM, AND NAVIGATION SYSTEM)DIAGNOSTIC INFORMATION AND PROCEDURESREDUCED VOLUME - ONE OR MORE SPEAKERSCIRCUIT/SYSTEM TESTING
2008 Chevrolet Chevy Express G2500, Van Cargo, 6.6 6
Circuit/System Testing
2008 Chevrolet Chevy Express G2500, Van Cargo, 6.6 6SECTION Circuit/System Testing
WARNING: This page is about a different car, the 2007 GMC Sierra and 2007 Chevrolet Silverado. However, it is still accessible from the selected car via links, so may be relevant.
Without Amplifier
- Center the balance and fade adjustment on the radio.
- If adjustment of the fade and balance eliminates the concern, review the operation of the radio with the customer.
- Turn ON the radio and tune the radio to a channel with no reception (static).
- Record the AC voltage of the suspect speaker channel and compare and verify the AC voltage output of the suspect low level audio signal is the same as the opposite low level channel.
- If the suspect speaker channel low level audio signal AC voltage is lower than other channels, replace the radio.
- If the recorded AC voltage is the same level as other speaker low level audio signal AC outputs, replace the suspect speaker.
With Amplifier
- Center the balance and fade adjustment on the radio.
- If adjustment of the fade and balance eliminates the concern, review the operation of the radio with the customer.
- Disconnect the harness connector containing the suspect low level audio circuits at the amplifier.
- Ignition ON and radio ON, tune the radio to a channel with no reception (static).
- Record the AC voltage of the suspect low level audio signal circuits. Compare and verify the AC voltage output of the suspect low level audio signal is the same as opposite low level channel.
- If the suspect speaker channel low level audio signal AC voltage is lower than other channels, replace the radio.
- Reconnect the harness connector containing the low level audio circuits and disconnect the harness connector at the individual speaker.
- Record the AC voltage of the suspect low level audio signal circuits. Compare and verify the AC voltage output of the suspect speaker signal is similar to other low level audio signal circuits.
- If the suspect channel speaker signal AC voltage is lower than other channels, replace the amplifier.
- If the recorded AC voltage is the same level as other speaker signal AC outputs, replace the suspect speaker.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.