Audio Amplifier X3 (UQA)

2008 Chevrolet Chevy Express G2500, Van Cargo, 6.6 6SECTION Audio Amplifier X3 (UQA)
WARNING: This page is about a different car, the 2007 GMC Sierra and 2007 Chevrolet Silverado. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Audio Amplifier X3 (UQA) Connector End Views
GM1653409Courtesy of GENERAL MOTORS CORP.
Audio Amplifier X3 (UQA) Connector Parts Information

Connector Part Information 
  • OEM: 15491285
  • Service: See Catalog
  • Description: 16-Way F Kaizan 0.64 (BK)
Terminal Part Information 
  • Pins: 4-8, 11-15
  • Terminal/Tray: 7116-4618-02/14
  • Core/Insulation Crimp: P/P
  • Release Tool/Test Probe: J-38125-215/J-35616-64B (L-BU)
Audio Amplifier X3 (UQA) Connector Terminal Identification

Pin Wire Color Circuit No. Function
1-2 - - Not Used
3 0.35 L-GN/WH 512 Right Front Low Level Audio Signal (+) (+Y91)
4 0.35 TN 1946 Right Rear Low Level Audio Signal (-) (-Y91)
0.35 OG/BK 1546 Front Low Level Audio Signal (-) (+Y91)
5 0.35 BN 1999 Left Rear Low Level Audio Signal (-) (-Y91)
0.35 GY 5836 Amplifier Audio Promp Signal (-) (Y91 +U3U/UVB)
6 0.35 OG/BK 1546 Front Low Level Audio Signal (-) (-Y91)
0.5 BARE 1489 Drain Wire (+Y91)
7 0.35 D-GN 1947 Left Front Low Level Audio Signal (-) (-Y91)
8 0.35 WH 7066 Entertainment Remote Enable Signal (-Y91)
9-10 - - Not Used
11 0.35 OG 6978 Amplifier Control (-Y91)
0.35 TN 511 Left Front Low Level Audio Signal (+) (+Y91)
12 0.35 D-BU 546 Right Rear Low Level Audio Signal (-Y91)
0.35 D-GN 1947 Left Front Low Level Audio Signal (-) (+Y91)
13 0.35 BN/WH 599 Left Rear Low Level Audio Signal (+) (-Y91)
0.35 PU 5837 Amplifier Audio Prompt Signal (+) (Y91 +U3U/UVB)
14 0.35 L-GN/WH 512 Right Front Low Level Audio Signal (+) (-Y91)
0.5 D-GN 1488 Noise Compensation Microphone Supply Voltage (+Y91)
15 0.35 TN 511 Left Front Low Level Audio Signal (+) (-Y91)
16 - - Not Used
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • You smell fuel, burning insulation, or see smoke.
  • Brakes feel soft, pull hard to one side, or make grinding noises.
  • The engine overheats, stalls repeatedly, or misfires under load.
  • You are missing required tools, torque specs, or safe lifting equipment.
  • You are not confident in the next step or safety outcome.