Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2008CHEVY EXPRESS G2500, VAN CARGO, 6.6 6REPAIR AND DIAGNOSISENGINE PERFORMANCETESTING & DIAGNOSISENGINE CONTROL SYSTEM & FUEL SYSTEM - 6.6L (LMM) - INTRODUCTION (2 OF 2)REPAIR INSTRUCTIONSFUEL INJECTION FUEL RAIL ASSEMBLY REPLACEMENT - BANK 1REMOVAL PROCEDURE
2008 Chevrolet Chevy Express G2500, Van Cargo, 6.6 6
Removal Procedure
2008 Chevrolet Chevy Express G2500, Van Cargo, 6.6 6SECTION Removal Procedure
- Remove the engine cover. Refer to Engine Cover Replacement .
- Remove the exhaust gas recirculation valve cooler assembly. Refer to Exhaust Gas Recirculation Valve Cooler Replacement .
- Remove the right fuel injector feed pipes. Refer to Fuel Injection Fuel Feed Pipe Replacement - Right Side .
- Disconnect the fuel rail pressure (FRP) sensor electrical connector (1).
- Disconnect the right fuel feed pipe fitting from the fuel rail.
- Remove the 2 fuel rail bolts and the fuel rail assembly.
- If replacing the fuel rail, remove the fuel pressure sensor.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.