Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2008CHEVY EXPRESS G2500, VAN CARGO, 6.6 6REPAIR AND DIAGNOSISENGINE PERFORMANCETESTING & DIAGNOSISENGINE CONTROL SYSTEM & FUEL SYSTEM - 6.6L (LMM) - INTRODUCTION (2 OF 2)REPAIR INSTRUCTIONSEXHAUST PRESSURE DIFFERENTIAL SENSOR REPLACEMENTREMOVAL PROCEDURE
2008 Chevrolet Chevy Express G2500, Van Cargo, 6.6 6
Removal Procedure
2008 Chevrolet Chevy Express G2500, Van Cargo, 6.6 6SECTION Removal Procedure
- Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle .
- Disconnect the engine wiring harness electrical connector (1) from the exhaust differential pressure sensor.
- Reposition the exhaust differential pressure sensor pipe assembly hose clamps (1).
- Remove the exhaust differential pressure sensor pipe assembly hoses from the sensor.
- Remove the exhaust differential pressure sensor bracket bolt (2).
- Remove the exhaust differential pressure sensor.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.