Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2008CHEVY EXPRESS G2500, VAN CARGO, 6.6 6REPAIR AND DIAGNOSISBRAKESANTI-LOCK BRAKE SYSTEM, TRACTION CONTROL SYSTEM & STABILITY CONTROL SYSTEMDIAGNOSTIC INFORMATION AND PROCEDURESBRAKE PRESSURE MODULATOR VALVE HYDRAULIC TESTINGDUMP AND ISOLATION VALVE TESTINGPRESSURE DUMP TEST PROCEDURE
2008 Chevrolet Chevy Express G2500, Van Cargo, 6.6 6
Pressure Dump Test Procedure
2008 Chevrolet Chevy Express G2500, Van Cargo, 6.6 6SECTION Pressure Dump Test Procedure
- Apply the parking brake fully.
- Start the engine and allow the engine to idle.
- Select the desired Dump Valve Solenoid Test on the scan tool.
- Apply the brake and maintain steady pressure on the brake pedal.
- Command the solenoid ON and verify that the brake pedal drops to the floor.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.