Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2008CHEVY EXPRESS G2500, VAN CARGO, 6.6 6REPAIR AND DIAGNOSIS (SINGLE PAGE)ACCESSORIES & EQUIPMENTHEADLIGHTSLIGHTING SYSTEMSREPAIR INSTRUCTIONSREAR FOG LAMP BULB REPLACEMENTINSTALLATION PROCEDURE
2008 Chevrolet Chevy Express G2500, Van Cargo, 6.6 6
Installation Procedure
2008 Chevrolet Chevy Express G2500, Van Cargo, 6.6 6SECTION Installation Procedure
- Install the bulb to the socket.
- Gently push in on the bulb and turn the bulb 1/4 turn clockwise.
- Install the lens to the lamp assembly.
- Install the screws to retain the lens to the lamp assembly.
Tighten: Tighten the screws to 1.5 N.m (13 lb in).
NOTE:
Refer to FASTENER NOTICE
.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.