SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2008CHEVY EXPRESS G2500, VAN CARGO EXTENDED, 6.0 KREPAIR AND DIAGNOSISSTEERINGSTEERING WHEEL & STEERING COLUMNREPAIR INSTRUCTIONSSTEERING COLUMN TRIM COVERS REPLACEMENTINSTALLATION PROCEDURE
2008 Chevrolet Chevy Express G2500, Van Cargo Extended, 6.0 K

Installation Procedure

2008 Chevrolet Chevy Express G2500, Van Cargo Extended, 6.0 KSECTION Installation Procedure
  1. Install the upper steering column trim cover to the closeout trim cover.
  2. Install the upper trim cover to the steering column.
  3. Install the Ignition lock cylinder.
  4. Install the lower trim cover and ensure that the tabs engage with the tabs on the upper trim cover. Snap the tabs together.
  5. Connect the lower steering column trim cover to the closeout trim cover.
    6. Fig 1: View Of Tilt Lever
    GM603840Courtesy of GENERAL MOTORS CORP.
  6. Install the tilt lever (1).
  7. Install the gap hider. Refer to Instrument Cluster Replacement .
  8. Install the steering wheel. Refer to Steering Wheel Replacement .
  9. Connect the battery negative cable. Refer to Battery Negative Cable Disconnection and Connection .
  10. Enable the SIR system. Refer to SIR Disabling and Enabling .
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.