Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Maintenance Schedule (European Emissions): Footnotes
The U.S. Environmental Protection Agency or the California Air Resources Board has determined that the failure to perform this maintenance will not nullify the emission warranty or limit recall liability prior to the completion of the vehicles useful life. We, however, urge that all recommended maintenance services be performed at the indicated intervals and the maintenance be recorded.
(1) Inspect every 3 000 km (1,900 mi) and replenish engine oil. If the vehicle is operated under severe conditions: short distance driving, extensive idling or driving in dusty conditions, change engine oil every 5 000 km (3,100 mi) or 3 months, whichever comes first.
(2) More frequent maintenance is required if driving in dusty conditions.
(3) Refer to Fluid and Lubricant RecommendationsΒ .
(4) Change the brake fluid every 15 000 km (9,000 mi) if the vehicle is mainly driven under severe conditions: driving in hilly or mountainous terrain.
(5) More frequent maintenance is required if used under severe conditions: short distance driving, extended idling, frequent low speed operation in stop-start traffic or driving in dusty conditions.
(6) Rotate and balance wheels, if necessary.
(7) Check the brakes during tire rotation
(8) Inspect every 5 000 km (3,000 mi)
(9) Rotate every 5 000 km (3,000 mi)
(10) Inspect when abnormal condition is noted.
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.