Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Removal Procedure
2008 Chevrolet Aveo LT, AutomaticSECTION Removal Procedure
- Turn OFF the ignition.
- Disconnect the electrical connector from the intake air temperature (IAT) sensor.
- Disconnect the breather tube from the air cleaner intake duct.
- Loosen the clamps securing the air cleaner intake duct.
- Remove air cleaner intake duct.
IMPORTANT:
The intake air temperature sensor is no longer replaced as a seperate service item. If the intake air temperature sensor is faulty, replacement of the entire air cleaner inlet duct will be necessary.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.