Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Scan Tool Data Definitions
The Data Display function contains lists of ABS and TCS data parameters. A brief description of all ABS and TCS data parameters available on the scan tool are listed below. The list is arranged in alphabetical order.
- ABS Warning Indicator
-
The scan tool will display On or Off depending on the state of the ABS indicator.
- Battery Voltage Signal
-
The scan tool displays 0 to 30 Volts. The voltage measured between the module's battery positive voltage circuit and ground circuit.
- Brake Switch
-
The scan tool displays Applied or Released. The scan tool displays the state of the brake switch.
- DRP Disabled
-
The scan tool will display Yes or No. This will indicate if the DRP has been disabled.
- LF Inlet Solenoid Command
-
The scan tool displays On or Off. The scan tool displays the commanded state of the LF inlet solenoid.
- LF Outlet Solenoid Command
-
The scan tool displays On or Off. The scan tool displays the commanded state of the LF outlet solenoid.
- LF Wheel Speed Sensor
-
The scan tool displays 0-255 km/h (0-158 mph). The scan tool displays the actual speed of the left front wheel.
- LR Inlet Solenoid Command
-
The scan tool displays On or Off. The scan tool displays the commanded state of the LR inlet solenoid.
- LR Outlet Solenoid Command
-
The scan tool displays On or Off. The scan tool displays the actual state of the LR outlet solenoid.
- LR Wheel Speed Sensor
-
The scan tool displays 0-255 km/h (0-158 mph). The scan tool displays the actual speed of the left rear wheel.
- Pump Motor Command
-
The scan tool displays On or Off. The scan tool displays the commanded state of the pump motor.
- Pump Motor Relay Command
-
The scan tool displays On or Off. The scan tool displays the commanded state of the pump motor relay.
- RF Inlet Solenoid Command
-
The scan tool displays On or Off. The scan tool displays the commanded state of the RF inlet solenoid.
- RF Outlet Solenoid Command
-
The scan tool displays On or Off. The scan tool displays the commanded state of the RF outlet solenoid.
- RF Wheel Speed Sensor
-
The scan tool displays 0-255 km/h (0-158 mph). The scan tool displays the actual speed of the right front wheel.
- RR Inlet Solenoid Command
-
The scan tool displays On or Off. The scan tool displays the commanded state of the RR inlet solenoid.
- RR Outlet Solenoid Command
-
The scan tool displays On or Off. The scan tool displays the commanded state of the RR outlet solenoid.
- RR Wheel Speed Sensor
-
The scan tool displays 0-255 km/h (0-158 mph). The scan tool displays the actual speed of the right rear wheel.
- Solenoid Relay Command
-
The scan tool displays On or Off. The scan tool displays the commanded state of the solenoid relay.
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.