SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2008AVEO LT, AUTOMATICREPAIR AND DIAGNOSIS (SINGLE PAGE)ENGINE PERFORMANCESYSTEMENGINE CONTROLS AND FUEL - 1.6L - DTC P0317 TO DTC P2610DTC P0442 OR P0456CIRCUIT DESCRIPTIONCONDITIONS FOR RUNNING THE DTC
2008 Chevrolet Aveo LT, Automatic

Conditions for Running the DTC

2008 Chevrolet Aveo LT, AutomaticSECTION Conditions for Running the DTC
  • DTCs P0106, P0107, P0108, P0112, P0113, P0116, P0117, P0118, P0122, P0123, P0131, P0132, P0133, P0134, P0135, P0137, P0138, P0140, P0141, P0201, P0202, P0203, P0204, P0300, P0402, P0404, P0405, P0406, P0443, P0451, P0452, P0453, P0454, P0461, P0462, P0463, P0464, P0488, P0498, P0499, P0502, P0506, P0507, P2110, P2195, and P2196 are not set.
  • One of the following conditions is met:
    • The ignition is off for greater than 12 hours.

      OR

    • The start-up intake air temperature (IAT) and the start-up engine coolant temperature (ECT) are within 8°C (46°F).
  • The ignition 1 voltage is between 11-16 volts.
  • The barometric pressure (BARO) is greater than 72 kPa.
  • The start-up ECT and start-up IAT are between 4-34°C (39-93°F).
  • The start-up IAT is 3°C (37°F) less than the actual IAT.
  • The purge enable time is less than pre-determined value based on startup ECT.
  • The fuel level is between 6-93 percent.
  • The engine run time is between 1-360 seconds plus purge enable time.
  • The engine is running.
  • The vehicle speed is less than 3 km/h (2 mp/h).
  • The throttle position is less than 1 percent.
  • The manifold absolute pressure (MAP) sensor is steady within than 5 kPa.
  • The DTCs run once an ignition cycle when the above conditions are met.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.