SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2007SUBURBAN C1500, 5.3 0REPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 1927 (AUTOMATIC TRANSMISSION - 6L80/6L90 - SPECIFICATIONS)SPECIFICATIONSFLUID PUMP SELECTIVE SPECIFICATIONS
2007 Chevrolet Suburban C1500, 5.3 0

Fluid Pump Selective Specifications

2007 Chevrolet Suburban C1500, 5.3 0SECTION Fluid Pump Selective Specifications
WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2011 GMC Yukon XL, 2011 GMC Yukon, 2011 Chevrolet Tahoe, 2011 Chevrolet Suburban, and 2011 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
Fluid Pump Selective Specifications

Size Classification Thickness (mm) Thickness (in)
NOTE:
  • Rotor and slide must be chosen from the same size classification as the oil pump body.
  • Allowable rotor and slide to fluid pump body end play is as follows:

    Specification 

    • Slide to Fluid Pump Body End Play - 0.020-0.051 mm (0.0008-0.0020 in)
    • Rotor to Fluid Pump Body End Play - 0.020-0.051 mm (0.0008-0.0020 in)
The fluid pump assembly has selective rotor and slide components. These components are chosen based on pump body dimensions. Fluid pump rotor and slide components are available in three size classifications (1, 2, 3) with the following tolerances:
Rotor Selection
1 17.948-17.961 0.7066-0.7071
2 17.961-17.974 0.7071-0.7076
3 17.974-17.987 0.7076-0.7081
Slide Selection
1 17.948-17.961 0.7066-0.7071
2 17.961-17.974 0.7071-0.7076
3 17.974-17.987 0.7076-0.7081
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.