SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2007SUBURBAN C1500, 5.3 0REPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 1921 (WIRING SYSTEMS AND POWER MANAGEMENT - COMPONENT CONNECTOR END VIEWS - ELECTRONIC STEERING CONTROL MODULE X2 THROUGH MEMORY SEAT MODULE)COMPONENT CONNECTOR END VIEWSGENERATOR CONTROL MODULE COOLANT PUMP- LEFT (HP2)
2007 Chevrolet Suburban C1500, 5.3 0

Generator Control Module Coolant Pump- Left (HP2)

2007 Chevrolet Suburban C1500, 5.3 0SECTION Generator Control Module Coolant Pump- Left (HP2)
WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2011 GMC Yukon XL, 2011 GMC Yukon, 2011 Chevrolet Tahoe, 2011 Chevrolet Suburban, and 2011 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Generator Control Module Coolant Pump - Left (HP2) Connector End View
GM1659331Courtesy of GENERAL MOTORS CORP.
Generator Control Module Coolant Pump- Left (HP2)

Pin Wire Circuit Function
1 0.8 BK 150 Ground
2 0.5 D-GN 942 Low Temperature Cooling Pump Motor Power
Connector Part Information
  • Harness Type: Forward Lamp
  • OEM Connector: 15383327
  • Service Connector: 88988054
  • Description: 2-Way F 1.5 Series, Sealed (BK)
Terminal Part Information
  • Terminated Lead: Pins 1- 13575424
  • Terminated Lead: Pins 2- Service by Connector Assembly- 88988054
  • Release Tool: J-38125-11A
  • Diagnostic Test Probe: J-35616-2A (GY)
  • Terminal/Tray: 7116-4103-08/9
  • Core/Insulation Crimp: E/1
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.